Most pod kit reviews answer the wrong question first. They open with a spec sheet, then a paragraph about the box, then a verdict that could apply to any device on the shelf. This review does it the other way round. It starts with the only question that matters to a buyer: what does the OXVA Xlim Pro 2 actually change about your daily vaping, and where does it fall short?
The short answer is that this is a refinement, not a revolution. OXVA took the original Xlim Pro, fixed its weakest point, which was battery life, gave it a far better screen, and tidied up the controls. What you get is a compact refillable pod kit that is genuinely easy to live with, with a couple of quirks you should know about before you buy.
Who should buy it, and who should walk past
Buy the Xlim Pro 2 if you want a small refillable kit that lasts a full day, you like a screen that shows real information, and you switch between a tight mouth to lung draw and a looser restricted direct lung draw. It suits ex smokers moving off disposables, and it suits experienced vapers who want a pocket friendly second device.
Walk past it if you need a physical fire button, because this version is draw activated only. Walk past it too if you want more than 30 watts, or if you want a device you can use without any light show. The RGB light bar cannot be switched off, so stealth vaping in a dark room is not really on the menu.
If you are still deciding between refillable kits in general, our roundup of the best refillable vapes puts the Pro 2 in context against the wider market.
The specs that actually matter
Plenty of reviews bury you in numbers. Only a handful of these numbers change how the device feels in your hand or performs through a day. Here they are, stripped down to what counts.
| Spec | OXVA Xlim Pro 2 |
|---|---|
| Battery | 1300mAh internal |
| Power output | 5 to 30 watts |
| Pod capacity | 2ml, top fill |
| Pods included | 0.6 ohm and 0.8 ohm top fill pods |
| Full pod range | 0.4, 0.6, 0.8 and 1.2 ohm |
| Screen | 0.56 inch HD colour TFT |
| Charging | USB-C, 5V/2A |
| Size and weight | 114.5 x 25 x 15 mm, 67 grams |
| Airflow | Side slider, adjustable |
| Activation | Draw activated |
The headline upgrade over the original Xlim Pro is the battery. It jumps from 1000mAh to 1300mAh, a 30 percent increase, while the weight stays almost identical at 67 grams. That is the single most important change in this review, because battery anxiety is what kills most small pod kits. A device that dies at 4pm is a device you stop trusting.
The second upgrade is the screen. The original had a small monochrome style display. The Pro 2 gets a proper 0.56 inch HD colour screen with three themes, one basic and two animated, plus a five digit puff counter and a clear battery percentage. It is small, but it is sharp, bright, and genuinely useful rather than decorative.
Design: pretty, but not without fingerprints
Pick up the Pro 2 and the first thing you notice is how balanced it feels. At 67 grams it is light enough to forget in a pocket, but heavy enough not to feel cheap. The airflow slider on the side is firm and precise, and the single button has a satisfying click. Build quality is a clear step above the budget end of the pod market, even if it does not quite reach the premium feel of the very best in class.
Looks are where OXVA clearly had fun. There are three panel styles across the colour range: carbon fibre, artificial leather, and a wavy brushstroke finish. The brushstroke versions, Dream Purple and Platinum Grey, are the standouts, with a depth that photographs badly and looks far better in person. The python finishes, in green, blue and brown, are the loudest options, while Black Carbon and Silver Carbon are the safe picks for a workday.
One more design note that matters in daily use: the pod sits in the device with magnets that are strong, but the pod still wobbles slightly side to side. It never falls out, and it never loses connection, but you will notice the movement when you fiddle with it. If a rock solid pod fit is high on your list, this is worth knowing.
The screen and the light bar: the best and worst of the Pro 2
The screen layout is close to ideal for a device this size. Wattage, coil resistance, battery percentage with a bar, and puff count are all visible at a glance, with no menu diving. Changing themes takes two clicks of the button. Switching to an animated theme also gives you a full screen battery percentage while charging, which is a small touch that makes topping up far less guesswork.
Then there is the light bar. A strip along the bottom of the screen lights up every time you vape or charge, shifting between green, blue, orange and red as a battery indicator. It looks great, and it genuinely helps you read battery level at a glance. The problem is that it cannot be turned off. If you vape at night, in a cinema, or anywhere you want to be discreet, the light bar announces itself.
Controls: simple to learn, fiddly to fine tune
OXVA deserves credit for how easy this kit is to learn. The box includes a quick start guide as the first thing you see on opening it, and a long press of the button brings the guide up on screen. The button commands are:
- One click to wake the screen
- Two clicks to switch display theme
- Three clicks to enter wattage adjustment
- Five clicks to power on or off
- Seven clicks to clear the puff count
- Long press to view the operating guide
Filling the pod is done without removing it from the device, thanks to a side fill port under a rubber tab. That is a real everyday convenience, and it keeps the whole process to seconds. The rubber tab itself can be stiff to open, especially with short nails, but it seals well once closed, and leaking is not a reported problem with these pods.
Pods and flavour: where the Pro 2 earns its money
Here is the honest truth about this device: the hardware is good, but the pods are what make it worth buying. The kit ships with two top fill pods, a 0.6 ohm pod for restricted direct lung vaping and a 0.8 ohm pod for mouth to lung vaping. The wider XLIM pod family also includes 0.4 ohm and 1.2 ohm options, so you can tune the kit to your style without buying a new device.
| Pod | Best for | Wattage range | Recommended setting |
|---|---|---|---|
| 0.4 ohm | Restricted direct lung | Up to 30W | Higher wattage, airier draw |
| 0.6 ohm | Restricted direct lung | 5 to 25W | 20 to 25W |
| 0.8 ohm | Mouth to lung | 5 to 18W | 12 to 16W |
| 1.2 ohm | Tight mouth to lung | Low wattage | Low wattage, high nicotine salts |
Flavour from both included pods is consistently rated among the best in the pod class. The 0.8 ohm pod delivers a tight, cigarette-like draw with clean, accurate flavour, and it handles both freebase nicotine and nicotine salts well. The 0.6 ohm pod is airier and warmer, and it holds up impressively with thicker high VG liquids, with no dry hits and no leaking reported across extended use.
Battery life and charging: the upgrade that counts
The 1300mAh battery is the Pro 2’s most meaningful improvement, and it shows in daily use. For a moderate mouth to lung vaper, this is comfortably an all day battery, and lighter users will stretch it well into a second day. Heavier restricted direct lung vapers at higher wattages will still need a top up by evening, but that is true of every device in this size class.
Charging is via USB-C at 2 amps, and a full charge takes roughly 45 minutes. OXVA advertises 80 percent in 25 minutes, but independent testing has found that figure optimistic, with around half charge in the same time. Treat the 45 minute full charge as the honest number and you will not be disappointed.
What it costs to own, not just to buy
The UK price band for the standard Xlim Pro 2 sits around £18 to £21, depending on the seller and any bundle deal. That puts it squarely in the middle of the refillable pod market: more than the cheapest starter kits, less than premium devices, and far cheaper than a month of disposables.
Running costs are where refillables win. Your ongoing spend is replacement pods plus e-liquid, and with pods lasting as long as these do, the monthly cost drops well below disposable use within the first few weeks. If you are switching from disposables, the kit pays for itself quickly, and then keeps saving you money every month after.
Pro 2 versus the original Pro, and versus its rivals
Against the original Xlim Pro, the Pro 2 is a clear upgrade in exactly the areas that mattered: battery, screen, and pod compatibility stays the same, so existing XLIM pod owners can upgrade without rebuying pods. The trade offs are the loss of button firing, since the Pro 2 is draw activated only, and wattage now steps in one watt increments rather than half watt steps. Neither trade off outweighs the battery and screen gains for most buyers.
Against its rivals, the picture is closer. The Vaporesso XROS line remains its toughest competition on flavour and build, and our XROS 6 review shows where that device edges ahead on polish. On the budget end, the Aspire GoTek line competes on price, and our OXVA versus GoTek comparison breaks down that fight in detail. For the head to head that most buyers actually ask about, see our Xlim versus XROS comparison.
What the Pro 2 offers over both rivals is balance. It does not have the single best flavour, the single best build, or the single lowest price. It has no weak category either, and for a device you use dozens of times a day, that evenness is worth more than a single standout feature.
The flaws, stated plainly
No review is honest if it hides the downsides, so here they are in one place:
- The RGB light bar cannot be switched off
- The pod wobbles slightly in the device
- Wattage scrolls too fast when holding the button
- The rubber fill tab can be stiff to open
- The glossy chassis attracts fingerprints and scratches
- Draw activation only, with no button firing option
- One early unit in independent testing arrived with a dead screen, which raises a quality control question worth noting, even though it appears to be the exception
None of these breaks the device. Together, they mean the Pro 2 is a very good kit rather than a perfect one, and a buyer who hates light shows or needs button firing should choose differently.
Setting it up: your first day with the Pro 2
Unbox the kit and you will find the device, a 0.6 ohm pod, a 0.8 ohm pod, a USB-C cable, a lanyard, and the guides. Start with the 0.8 ohm pod if you are coming from cigarettes or disposables, since its tighter draw feels most familiar. Fill it through the side port, wait five minutes, click five times to power on, and take a gentle first draw. Set the wattage low, around 12 watts, and adjust up from there. Use the airflow slider to tighten or loosen the draw until it feels right.
For the 0.6 ohm pod, open the airflow further and set the wattage between 20 and 25 watts. This is the pod to reach for if you want bigger clouds and warmer vapour, or if you use lower nicotine freebase liquids.
The verdict
The OXVA Xlim Pro 2 is the rare pod kit that gets the fundamentals right and then adds just enough polish to feel special. The battery lasts, the screen informs, the pods taste excellent and last well, and the whole thing is easy enough for a first time vaper to learn in minutes. Its flaws are real but small: a light bar you cannot silence, a pod that wobbles, a wattage control that rushes, and a finish that shows fingerprints.
If you want a dependable daily refillable kit at a fair UK price, buy it, and start with the 0.8 ohm pod. If you need button firing, total discretion, or more than 30 watts, look elsewhere. For everyone in between, and that is most vapers, this is one of the easiest recommendations in the pod market right now.
For more on the site, start at the VapeFeat home page and browse the latest reviews.
Frequently asked questions
Is the OXVA Xlim Pro 2 good for beginners?
Yes. It is draw activated, it ships with a quick start guide in the box and on screen, and the pod system means there are no coils to change and no settings you must understand before your first puff.
How long does the battery last?
The 1300mAh battery lasts a full day for most mouth to lung vapers, and lighter users will get into a second day. Heavy restricted direct lung use at high wattage will need an evening top up.
Which pods fit the Xlim Pro 2?
It uses the XLIM pod family, including top fill pods in 0.4, 0.6, 0.8 and 1.2 ohm resistances. The kit includes 0.6 ohm and 0.8 ohm pods.
How much does the Xlim Pro 2 cost in the UK?
The standard edition typically sells for around £18 to £21 in the UK. The DNA edition costs more, usually around £23 to £30, and is aimed at enthusiasts.
Does the Xlim Pro 2 leak?
Leaking is not a commonly reported problem with these pods. The top fill design and rubber sealed fill port keep e-liquid where it belongs, provided the fill tab is pushed fully closed after refilling.